Cutting-edge high-tech selected and formatted NiMH-High Performance batteries are incorporated into the clearaudio Accu+ power supply unit which can be used to upgrade clearaudio "+" series phonostages to run on the purest DC Voltage possible.
Battery power guarantees that no noise or distortion from the mains supply can pollute the delicate phono signal, producing the highest quality music reproduction and listener pleasure.
The clearaudio Basic+, Symphono+ and Balance + phonostages can all be upgraded with the new Clearaudio ACCU+ Power Supply.
Through innovative battery technology the Clearaudio ACCU+ Power Supply elevates the Clearaudio "+" phonostages to a new level of excellence.
Power Supply: Input 115 V / 230 V selectable by switch inside the power supply
Output +/- 10 V and +/- 17 V
Signal to noise ratio: 75 dB(A), G=60 dB
Channel separation: > 90 dB
Gain / Amplification: (1 kHz) 30 dB - 63 dB selected by rotary switch
Clipping limit: (1 kHz) G=60 dB, 11mV
Distortion: (1 kHz) less than < 0.001 %
Input impedance: adjustable from 0 Ohms to 47 kOhms
Output impedance: 50 Ohm
System response: RIAA / DIN IEC 98
+/- 1 dB tolerance
Frequency response: 10 Hz - 100 kHz / - 0.1 dB
In- and Outputs XLR: Pin 1 = GND (Shield)
Pin 2 = Hot (+)
Pin 3 = Cold (-)
5-pin Binder-connector: Pin 1 = Hot (+)
Pin 2 = Cold (-)
Pin 3 = GND (Shield)
Pin 4 + 5 = n.c.
Power Supply 9-pin. D-SUB-Connector: Pin 1 = -10 V, Pin 2 = +10 V
Pin 3 = -17 V, Pin 4 = +17 V, Pin 5 = free
Pin 6 - 9 = GND